Filter
Top Products
132 Installing System Components
5
Install the optical drive carrier.
Slide the drive carrier into its drive bay and press in the release latch. See
Figure 3-20
.
6
Install the SAS hard drives in their original locations. See "Installing a Hot-
Plug Hard Drive" on page 109.
7
Close the system. See "Closing the System" on page 66.
8
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
System Board (Service-Only Procedure)
Removing the System Board
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2
Open the system. See "Opening the System" on page 65.
3
Remove the PEM. See "Removing the PEM or PEM Shell" on page 73.
4
Remove the cooling shroud assembly. See "Removing the Cooling Shroud
Assembly" on page 69.
5
Remove all expansion cards and the SAS controller card. See "Removing an
Expansion Card" on page 80.
6
If installed, disconnect and remove the RAC card.
7
If installed, remove the internal USB key and SD card.
8
If installed, remove the TOE/iSCSI key.
9
Remove the riser board. See "Removing the Riser Board" on page 81.
10
Remove the NIC daughter card. See "Removing the NIC Daughter Card"
on page 91.
11
Disconnect all cables from the system board.