Filter
Top Products
4-10 Dell Dimension XPS H233 and XPS H266 Systems Service Manual
Primary Hard-Disk Drive
Figure 4-10. Primary Hard-Disk Drive Removal
To remove the primary hard-disk drive, follow these steps:
1. Remove the front bezel.
2. Remove the two mounting screws.
3. Lift the primary hard-disk drive out of the card guide assembly.
4. Disconnect the power and interface cables from the back of the primary
hard-disk drive.
When you reinstall the primary hard-disk drive, be sure the circuit board is
toward the front of the chassis.
When you replace a hard-disk drive, be sure to set the jumpers on the replace-
ment drive the same as the jumpers on the drive you removed. For additional
information about jumper settings on EIDE drives, see “EIDE Subsystem” in
Chapter 1.
primary hard-
disk drive
card guide assembly
mounting screws (2)