Filter
Top Products
A-8 Dell Dimension XPS H233 and XPS H266 Systems Service Manual
Peripheral Configuration Submenu
Figure A-5. Peripheral Configuration Submenu
Table A-5. Peripheral Configuration Submenu
Categories
Category Function
Primary PCI IDE Interface Configures the primary EIDE interface on the
system board. Options for this category are
Auto Configured (the default) and Disabled.
Secondary PCI IDE
Interface
Configures the secondary EIDE interface on
the system board. Options for this category are
Auto Configured (the default) and Disabled.
Floppy Interface Configures the diskette/tape drive interface on
the system board. Options for this category are
Auto Configured (the default), Enabled (which
locks the interface at I/O port address 3F0h–
3F5h), and Disabled.
Serial Port 1 Interface Configures the built-in serial port on the sys-
tem board. You can set this category to Auto
Configured (the default) or to Disabled, or you
can select a specific port designation, I/O
address, and IRQ line for the port. The avail-
able port designations are COM1, COM2,
COM3, and COM4; available I/O addresses are
3F8h, 3E8h, 2F8h, and 2E8h; and available
interrupts are IRQ3 and IRQ4.