Filter
Top Products
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
The following fields can be set:
Parameter Description
Interface name:
[ ]
The name of the IP interface on which RIP is to be setup.
This interface must be previously configured on the
switch.
TX Mode
<Disabled>
Toggle among Disabled, V1 Only, V1 Compatible, and V2
Only. This entry specifies which version of the RIP
protocol will be used to transmit RIP packets. Disabled
prevents the transmission of RIP packets.
RX Mode
<Disabled>
Toggle among Disabled, V1 Only, V2 Only, and V1 and
V2. This entry specifies which version of the RIP protocol
will be used to interpret received RIP packets. Disabled
prevents the reception of RIP packets.
Authentication:
Disabled
Toggle between Enabled and Disabled. When
authentication is enabled, a password is used to
authenticate communication between routers on the
network. Authentication is only supported when RIP is in
V1 Compatible or V2 only mode.
Password:
A password to be used to authenticate communication
between routers on the network.
Setup Open Shortest Path First (OSPF)
MD5 Key Table Configuration
To access the MD5 Key Table Configuration screen, highlight MD5 Key Table Configuration on the
menu above, and press Enter.
Figure 6-41. MD5 Key Table Configuration screen
123