Filter
Top Products
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
The following fields can be set:
Parameter Description
Interface
Name<System>
Allows the entry of the name of the IP interface for which
DVMRP is to be configured. This must be a previously
defined IP interface.
IP Address
Displays the IP address corresponding to the IP Interface
name entered above.
Probe Interval
<10>
This field allows an entry between 0 and 65,535 seconds
and defines the interval between ‘probes’. The default is
10.
Nbr Report Timer
<35>
This field allows an entry between 1 and 65,535 seconds
and defines the time period for DVMRP will hold Neighbor
Router reports before issuing poison route messages. The
default is 35 seconds.
Route Cost <1> This field allows an entry between 1 and 255 and defines
the route cost for the IP interface. The DVMRP route cost
is a relative number that represents the real cost of using
this route in the construction of a multicast delivery tree.
It is similar to, but not defined as, the hop count in RIP.
The default cost is 1.
State <Disabled> This field can be toggled between Enabled and Disabled
and enables or disables DVMRP for the IP interface. The
default is Disabled.
PIM-DM Settings
To configure PIMDM for an IP interface:
Click the PIMDM Interface Configuration link:
Figure 7-45. PIM-DM Interface Configuration window
230