Filter
Top Products
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Figure 7-29. Setup RIP window
To edit a RIP configuration, click the Hand icon.
Figure 7-30. Setup RIP – Edit window
The following fields can be set:
Parameter Description
Subnet Name
The name of the IP interface on
which RIP is to be setup. This
interface must be previously
configured on the Switch.
TX Mode
<Disabled>
Toggle among Disabled, V1 Only, V1
Compatible, and V2 Only. This entry
specifies which version of the RIP
protocol will be used to transmit RIP
packets. Disabled prevents the
transmission of RIP packets.
RX Mode
<Disabled>
Toggle among Disabled, V1 Only, V2
Only, and V1 and V2. This entry
specifies which version of the RIP
protocol will be used to interpret
received RIP packets. Disabled
prevents the reception of RIP
packets.
Password
A password to be used to
authenticate communication
between routers on the network.
Authentication
Toggle between Disabled and
Enabled to specify that routers on
the network should us the Password
above to authenticate router table
exchanges.
216