Filter
Top Products
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
The following fields can be set:
Parameter Description
Interface Name:
[ ]
Allows the entry of the name of the IP interface for which
DVMRP is to be configured. This must be a previously
defined IP interface.
NBR Report
Timer:[35 ]
This field allows an entry between 1 and 65,535 seconds
and defines the time period for DVMRP will hold Neighbor
Router reports before issuing poison route messages. The
default is 35 seconds.
Route Cost:[1 ] This field allows an entry between 1 and 255 and defines
the route cost for the IP interface. The DVMRP route cost is
a relative number that represents the real cost of using this
route in the construction of a multicast delivery tree. It is
similar to, but not defined as, the hop count in RIP. The
default cost is 1.
State:<Disabled> This field can be toggled between Enabled and Disabled and
enables or disables DVMRP for the IP interface. The default
is Disabled.
IP Address:
Displays the IP address corresponding to the IP Interface
name entered above.
Probe Interval:
[10 ]
The Probe Interval field allows an entry between 1 and
65,535 seconds and defines the interval between ‘probes’.
The default is 10.
PIM-DM
To configure PIMDM for an IP interface:
Highlight PIMDM Interface Configuration from the Setup IP Multicast menu and press Enter.
Figure 6-59. PIM-DM Interface Configuration screen
141