Filter
Top Products
RiverMaster Administrator’s Guide
219
Appendix B Adding Remote Gateways
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
Figure 121 Add Remote ANG Window
NOTE
Unless you are configuring a tunnel from the ANG/APS pair to a Remote
ANG, you only need to enter the Remote Gateway Name and IP Address.
4 Enter a Remote Gateway Name and IP address in the fields provided.
5 Type a User Name, User Password and confirm the password.
This User Name and Password must also be registered in the
authentication database in the ANG at the remote site by adding the
user to a group (Refer to Chapter 6 for more information).
6 Choose the tunneling protocol: IPSec or PPTP.
7 Click Add.
The Remote ANG is added to the configuration on your local ANG. A
message displays stating the Remote ANG was successfully added.
Because the preceding configuration information is not immediately
written to a floppy disk, we strongly recommend you repeat this
procedure for all Remote ANGs you plan to add.