Filter
Top Products
222
RiverMaster Administrator’s Guide
Configuring Tunnel Protocols Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
For each tunnel protocol, you can configure authentication, encryption, and
compression parameters. To set tunnel protocol parameters, continue floppy
disk configuration with the following steps.
Figure 123 General Tab of Tunnel Protocols Window
1 If you want to prevent the Remote Gateway from using one of the
tunnel protocols, select the protocol and click Remove.
By default, PPTP and IPSec are both enabled. You normally control
protocol usage on a per group basis by selecting the protocol when
you assign group policies (refer to Chapter 6 of the RiverMaster
Administrator’s Guide for instructions). If you want to globally disable
a protocol, you can remove it from this list. If you have removed a
protocol and want to reinstall it, click Add once and when the
highlighted tunnel protocol pops up, click Add again. You are not
required to click Apply.