Filter
Top Products
68
RiverMaster Administrator’s Guide
Adding a Remote Server Chapter 3
Configuring an ANG-3000/7000
Adding a Remote Server
An ANG can be added at a remote location in a Site-to-Site configuration.
This section describes how to set up an initiating Network Gateway to connect
to a Local or terminating ANG/APS pair.
NOTE
Local ANGs use an accompanying APS; remote ANGs are stand-alone.
These instructions cannot be used to configure a stand-alone ANG connection
to another stand-alone ANG (refer to Appendix B for more information).
To add a Remote Network Gateway, perform the following steps.
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under gateways
(click the + symbol).
3 Expand the tree list under Remote Servers.
The Tunnel Protocols window appears as shown in Figure 39.
Figure 39 Remote Server Display
Click here to
access the
Click here to
add the Remote
Click here to
open the
Click
Click
C
C
Click here to display the configured properties of the selected device
Gateway or Tunnel
Network Gateway
configuration
Click here to
expand the
Click here to
select the
created server
Configuration
pullout
tree list
or tunnel
windows