Filter
Top Products
64 RiverMaster Administrator’s Guide
Routing
Chapter 3
Configuring an ANG-3000/7000
ConfiguringOSPFonanInterface
To enable OSPF on an interface, perform the following steps:
1
Add OSPF as described in “Adding or Removing a Routing Protocol
for an Interface” on page 60 or select OSPF from the Routing
Protocols list and click Properties.
The OSPF Interface Configuration window appears as shown in
Figure 37.
Figure 37 Routing Interfaces Configuration - OSPF
2
Type the OSPF password used by routers on your network in the
Authentication Password field.
OSPF authentication passwords are used by routers to determine if
they should accept updated routing information sent from another
router. If your routers do not authenticate updates, leave this field
blank.
NOTE
Passwords are limited to 8 characters or less
3 Type the same password in the Re-Type Authentication Password
field exactly as you entered it in Step 2.