Filter
Top Products
236
RiverMaster Administrator’s Guide
Configuring Routing Interfaces Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
Figure 134 Adding a Routing Protocol
NOTE
For the External interface, you can only add or remove static routing.
Because the External interface is optimized for tunnel protocols only, you
cannot use RIP or OSPF on this interface.
5 Do one of the following:
– If you are adding RIP to the interface, perform the steps in
“Configuring RIP for the Interface” on page 236.
– If you are adding OSPF to the interface, perform the steps in
“Configuring OSPF on an Interface” on page 238.
– If you are adding a static route to the interface, perform the steps
in “Creating Static Routes” on page 239.
Configuring RIP for the Interface
To configure RIP on an interface, continue floppy disk configuration with the
following steps:
1 In the RIP Interface window, shown in Figure 135, choose the version
of RIP to use on this interface.
RIP Version 1 uses IP broadcast packets for periodic announcements
of reachable subnets. RIP Version 2 is an enhanced version of RIP that
uses IP multicast packets for announcements.