Filter
Top Products
RiverMaster Administrator’s Guide 61
Chapter 3
Routing
Configuring an ANG-3000/7000
6
Select the interface (Trusted or External) from the list under Network
Interfaces.
The protocols already enabled for this interface appear in the Routing
Protocols list.
7
Do one of the following:
– To add a protocol to the trusted interface, click Add and continue
with the next step.
– To remove a protocol, select the protocol from the Routing
Protocols list and click Remove. Skip to Step 10.
8
When the Add an Interface Routing Protocol window appears as
shown in Figure 35, select a routing protocol and click Add.
Figure 35 Adding a Routing Protocol
NOTE
For the External interface, you can only add or remove static routing.
Because the External interface is optimized for tunnel protocols only, you
cannot use RIP or OSPF on this interface.
9
Do one of the following:
– If you are adding RIP to the interface, perform the steps in
“Configuring RIP for the Interface” on page 62.
– If you are adding OSPF to the interface, perform the steps in
“Configuring OSPF on an Interface” on page 64.
– If you are adding a static route to the interface, perform the steps
in “Creating Static Routes” on page 65.
10
Do one of the following:
– Click Apply to save the routing protocol configuration changes.
– Click Reset to the return the interface’s protocol configuration to
its original setting.