Filter
Top Products
Note:
If the status sheet does not print, first make sure that the printer is
on line. If it is on line but the status sheet still does not print, you
will have to reset the printer by turning it off and back on.
R
Caution:
After turning off the power, wait at least five seconds before
turning it back on; otherwise you may damage the printer.
Report printing is available after the printer is turned on and has
completed its initialization routine. The Status Sheet is not
available when the printer has started printing or when the
printer is off line or not ready.
Under normal operating conditions, the status sheet will print
in one of the following emulation modes: ESC/P*-**, ESC/Page,
PCL (LJ-2P, S/P/Si, LJ-4P), GL (HP-GL, HP-GL2, EP-GL),
EpsonScript (PostScript), PR-201, GQ.
Using the EPSON PostScript card
If your printer has an EpsonScript (PostScript) card installed,
allow a minute for the printer to initialize before trying to install
or configure the Ethernet Card on the network. The Ethernet
Card may not respond if initialization has not been completed.
Network installation
See the appropriate chapter in this guide for instructions on
installing the card on a specific network.
1-6
Installing the Ethernet Card