Filter
Top Products
103
Projector Monitoring and Control using a NetworkProjector Monitoring and Control using a Network
Once the settings have been made, press the [Menu]
button to close the configuration menu.
Problem Reporting Using the Mail Notification
Function
If EMP NetworkManager has been used to make the settings for the mail
notification function, notification messages can be sent to a computer with
a preset e-mail address when a problem or warning occurs with a projector
connected to the network. This will notify the e-mail recipient that there is
a problem with the projector.
Check the following points before starting up EMP NetworkManager.
• EMP NetworkManager must be installed in the computer to be used for
monitoring and control. p.100
• The computer and the projector must be connected to the network.
p.101
Projector name (EMP-9300 only)
The projector name is a unique name that is used to
distinguish the projector from other projectors on a
network. Use EMP NetworkManager to change the
projector name. p.104
3
TIP
Once the projector has been connected to the network, EMP
NetworkManager can be used to change the projector's network
settings. p.104
TIP
• Up to a maximum of three notification destinations (addresses) can
be recorded, and notification messages can be sent to all three
destinations at once.
• If a critical problem develops with a projector which causes it to
suddenly stop working, it may not be possible for the projector to
send a message notifying an operator of the problem.
• If "Standby Mode" in the projector's "Advanced1" menu is set to
"Network ON", monitoring can be carried out even when the
projector is in standby mode (when the power is off). p.91