Filter
Top Products
133
MaintenanceMaintenance
PROCEDURE
Turn the projector's power off, wait for the cool-down
period to end, and then disconnect the power cable.
The cool-down period lasts for about 30 seconds.
Wait until the lamp has cooled down, and then
remove the lamp cover from the base of the projector.
It takes a further one hour after the cool-down period has
finished for the lamp to be cool enough.
Use the screwdriver that is supplied with the spare lamp or
some other Phillips screwdriver to remove the two lamp cover
fixing screws. Be careful not to let the lamp cover fall down
after the fixing screws have been removed.
Loosen the three lamp fixing screws.
Use the screwdriver that is supplied with the spare lamp or
some other Phillips screwdriver to loosen the three lamp fixing
screws that are securing the lamp to the projector.
Replacing the Lamp
CAUTION
• If you are replacing the lamp because it has stopped working, it is
possible that the lamp is broken.
If replacing the lamp of a projector which has been installed to the
ceiling, you should always assume that the lamp is broken and be
extremely careful when removing the lamp cover.
• Wait until the lamp has cooled down sufficiently before removing the
lamp cover. It takes a further one hour after the cool-down
period
has finished for the lamp to be cool enough.
1
TIP
If the projector has been installed on the ceiling and the cable cover
has been attached, remove the cable cover before proceeding. p.35
2
3