Epson EMP-8300 Projector User Manual


 
46
Turning the Projector Off
Follow the procedure below to turn the projector off.
PROCEDURE
Turn the power off for the signal sources that are
connected to the projector.
Check that the power for all connected components has been
turned off.
Press the [Power] button on either the remote control
or the projector's control panel.
The following confirmation message will appear.
If you do not want to turn the power off, press a button other
than any of the following:
At the remote control: [Power], [ ], [ ], [ ], [Num], [ID]
At the control panel : [Power]
If you do not press any button, the message will disappear
automatically after seven seconds. (The power will not turn off
at this time.)
Press the [Power] button on either the remote control
or the projector's control panel once more.
The lamp will switch off. The indicator will flash orange and
cool-down
will start.
The cool-down period lasts for about 30 seconds.
When cool-down is complete, the indicator lights orange.
1
2
Remote control
Power OFF?
Yes
: Press button
No : Press any other button
TIP
If the message "The projector is overheating. Clean or replace the air
filter and lower the room temperature." appears on the screen, press
the [Enter] button on the remote control or the [Auto/Enter] button on
the projector's control panel to turn the power off and then clean the
air filters. p.130
3
Stops flashing and lights orange
TIP
The remote control and projector's control panel buttons cannot be
operated while the indicator is flashing orange. Wait until it lights
constantly.