Filter
Top Products
118
Problem SolvingProblem Solving
Lamp replacement notification Replace the lamp with a new one. p.133
If you continue to use the lamp after it has passed the replacement period, the possibility that the
lamp may break will increase. Replace the lamp with a new one as soon as possible.
* The indicator status will vary depending on the projector status at the time.
Standby condition (Not abnormal)
Press the [Power] button on either the remote control or the projector's control panel to start
projection.
When turning off the projector's power, disconnect the power plug from the electrical outlet when
the projector is in this condition.
Warm-up in progress (Not abnormal)
Please wait. Warm-up time is approximately 40 seconds. After warm-up is complete, the flashing
green indicator changes to steady green.
Projection in progress (Not abnormal)
Cool-down in progress (Not abnormal)
Please wait.
•The cool-down period lasts about 30 seconds. (This varies depending on factors such as the
ambient air temperature.)
•You cannot operate the [Power] button on either the remote control or the projector's control
panel during cool-down. Press the button again after cool-down ends and the indicator changes to
steady orange.
: lit : flashing : off
Status Cause Remedy or Status
Orange
Orange
Green
Green
Orange