Filter
Top Products
38
Preventing theft (Password Protect)(EMP-9300 only)
Turn "Power ON Protect" on.
(1) Select "Power ON Protect".
(2) Select "ON" and then press the [Enter] button on the
remote control.
(3) Press the [ESC] button.
The next time the "Timer" setting is made, you can set the time
that the projector can be used without needing to enter a
password.
If setting the time, continue on to the next step. If not setting the
time, continue on to step 5.
Select "Timer" and then press the [Enter] button.
Enter up to four numeric characters for the time being
set.
Press the [Num] button on the remote control and then use the
numeric keypad buttons to enter a setting time within the range
of 0 to 9999 hours, then press the [Enter] button. If you make a
mistake entering the time, press the [Esc] button and re-enter
the time.
A message will appear after this.
When you have finished using the "Password Protect" menu,
the countdown for the elapsed time will start.
Turn "User’s Logo Protect" on.
(1) Select "User’s Logo Protect".
(2) Select "ON" and then press the [Enter] button on the
remote control.
(3) Press the [ESC] button.
l
To set a password, select "Password" and then press
the [Enter] button on the remote control.
The message "Change the password?" will be
displayed, so select "Yes" and then press the [Enter]
button on the remote control.
The default setting for the password is "0000", but you should
be sure to change this to your own desired password.
If you select "No", the screen shown at step 1 will be displayed
again.
Enter a 4-digit password.
Press the [Num] button on the remote control, and then use the
numeric keypad to enter a 4-digit number.
The password entered will be displayed as "* * * *".
When the 4th digit is entered, the following confirmation screen
will be displayed.
2
TIP
The portion of the length of time set that has already been used can be
checked using the "Time-elapsed" command.
3
4
TIP
If the length of time is set to "0", the password entry screen will only
be displayed when the power is turned on again for the first time after
the power plug has been disconnected from the wall outlet.
5
6
7
8