Filter
Top Products
41
Turning the Projector On
Turn the power on to start projecting images.
Connecting the Power Cable
PROCEDURE
Check that the power is turned off for the projector
and all components connected to the projector.
Connect the computer or other video source to the
projector. p.18, p.26
Remove the lens cover.
Hook your finger under the top of the lens cover and pull to
remove it.
Connect the accessory power cable to the projector.
Check that the power connector is facing the same way as the
power inlet on the projector, and then insert the power cable
connector securely into the projector.
Connect the other end of the power cable to an
earthed electrical outlet.
Wait until the indicator lights orange.
CAUTION
Be sure to read the Safety Instructions/World-Wide Warranty Terms
before projecting images.
TIP
With the EMP-9300, if you change the setting for the "Direct Power
ON" command in the "Advanced2" menu to "ON", the projector's
power will turn on and projection will start at once when you insert
the power plug into the wall outlet. p.93
First turn on the power for other components that are connected to
the projector.
1
2
3
4
5
Lit orange
CAUTION
When the power is first turned on after attaching the standard lens or
wide angle zoom lens, continue with the configuration menu "Reset
All". p.95
If you do not select "Reset All", the images may appear slightly dark.