Filter
Top Products
43
Turning the Projector On
If more than one external device is connected to the
projector, use the remote control or projector control
panel buttons to select the image source to be
projected while referring to the following table.
You can also use the preview function to select the signal
source. p.44
*1 When these buttons are pressed once, the signal name that is currently
set using the configuration menus appears on the screen. You can
change the signal setting by repeatedly pressing the button while the
signal name is displayed. The result of this switching will also be
applied to the "Computer1 Input", "Computer2 Input" or "BNC Input"
setting in the "Setting" menu.
*2 The input signal will not change to the next signal source unless the
[Computer/DVI] button is pressed while the current signal name is still
being displayed on the screen.
If an input signal from either the [DVI], [Computer 1] or [Computer 2]
port is currently being projected, the name of this current input signal
will be displayed on the screen when the [Computer/DVI] button is
pressed once.
*3 The item selected using the "Computer1 Input" command in the
"Setting" menu will appear. You can change the setting by pressing the
[Comp1] button on the remote control.
*4 The item selected using the "Computer2 Input" command in the
"Setting" menu will appear. You can change the source by pressing the
[Comp2] button on the remote control.
*5 The input signal will not change to the next signal unless the [Video/
BNC] button is pressed while the current signal name is still being
displayed on the screen.
If an input signal from either of the [BNC], [S-Video] or [Video] ports
is currently being displayed, the name of this current input signal will
be displayed on the screen when the [Video/BNC] button is pressed
once.
*6 The item selected using the "BNC Input" command in the "Setting"
menu will appear. You can change the source to the next source in order
by pressing the [BNC] button on the remote control.
Port
Button to press
On-screen display
Remote
control
Projector
DVI
[DVI]
The image
source changes
each time
[Computer/
DVI] is
pressed.
*2
DVI
Computer 1
[Comp1]
*1
Computer1
(Analog-RGB)
*3
Computer1
(RGB-Video)
*3
Computer 2 [Comp2]
*1
Computer2
(Analog-RGB)
*4
Computer2
(RGB-Video)
*4
BNC [BNC]
*1
The image
source changes
each time
[Video/BNC] is
pressed.
*5
BNC(Analog-RGB)
*6
BNC(RGB-Video)
*6
BNC(YCbCr )
*6
BNC(YPbPr )
*6
S-Video [S-Video] S-Video
Video
[
Video
]
Video
5
Remote control