Filter
Top Products
5
Introduction | 5
Important Safety Instructions
Before using your printer and RIP, read the following safety instructions to
make sure you use the equipment safely and effectively.
•
Turn off and unplug the printer (and RIP) before cleaning. Clean with a
damp cloth only. Do not spill liquid on the printer (or RIP).
•
Do not place the printer (or RIP) on an unstable surface or near a
radiator or heating vent.
•
Place the printer (and RIP) on a flat surface. They will not operate
properly if they are tilted or at an angle.
•
Do not block or cover the openings in the printer’s (or RIP’s) cabinet or
insert objects through the slots.
•
Use only the type of power source indicated on the label.
•
Connect all equipment to properly grounded power outlets. Avoid using
outlets on the same circuit as photocopiers or air control systems that
regularly switch on and off.
•
Place the printer and RIP near a wall outlet where the plugs can be easily
unplugged.
•
Placez l’imprimante près d’une prise de contacte où la fiche peut être
débranchée facilement.
•
Do not let the power cords become damaged or frayed.
•
Except as specifically explained in the documentation, do not attempt to
service the printer (or RIP) yourself. Opening or removing those covers
that are marked “Do Not Remove” may expose you to dangerous
voltage points or other risks. Refer all servicing in those compartments
to service personnel.
•
Unplug the printer (or RIP) and refer servicing to qualified service
personnel under the following conditions:
If the power cord or plug is damaged; if liquid has entered the printer
(or RIP); if the equipment has been dropped or the cabinet damaged; if
the printer (or RIP) does not operate normally or exhibits a distinct
change in performance. Adjust only those controls that are covered by
the operating instructions.