Filter
Top Products
2-9
Monitoring the Printer | 2-9
Paper Unit Open
The multipurpose tray is pulled out. Push in the multipurpose tray.
Photoconductr
Trouble
The photoconductor unit has a problem. Turn off the printer and replace
the photoconductor unit.
page 4-10
Replace Oil Roll
The fuser oil roll is empty. Replace the fuser oil roll. page 4-6
Replace
Photoconductr
The photoconductor unit has reached
the end of its service life.
Replace the photoconductor unit. page 4-10
Replace Waste T
Box
The waste toner collector is full. Replace the waste toner collector. page 4-15
Service req e
<error number>
A controller error or a print engine error
has been detected.
Write down the error number and
turn off the printer. Wait at least
10 seconds and then turn it back
on. If this error still appears, turn
off the printer, unplug the power
cord, and contact IKON.
page 4
<CMYK>
Toner
Crtg Out
The indicated toner cartridge is missing. Install the indicated toner
cartridge.
page 4-2
<CMYK>
Toner
Out
The indicated toner cartridge is empty. Replace the toner cartridge. page 4-2
Turn Paper
Paper is loaded incorrectly. Turn the paper 90 degrees. page 1-7
Write Error
DIMM A
An internal error has occurred in the
printer.
Reset the printer by holding down
the Alt and Reset buttons until
Reset appears on the display. If
the error is not cleared, contact
IKON.
page 4
Wrong
Photoconductor
The wrong photoconductor unit has
been installed.
Turn off the printer and replace
the photoconductor unit.
page 4-10
Error messages (continued)
Message Explanation Response See