Filter
Top Products
4-10
4-10 | Maintaining and Transporting the Printer
7. Slide the fuser unit back into the printer.
Replacing the Photoconductor Unit
When you see one of the following messages on the control panel display,
you should replace the photoconductor unit:
• Warning Photoconductr
• Photoconductr Trouble
•Wrong
Photoconductr
• Replace Photoconductr
When you see the
Warning Photoconductr
message, you can press
Continue
to print. Make sure you have a replacement photoconductor (part
number S051061). You will only be able to print for a short time before the
Replace Photoconductr
message will appear, and the printer will stop.
Since the waste toner collector is part of the photoconductor unit, it is
replaced at the same time. Occasionally, the waste toner collector may need
to be replaced separately. See page 4-15 for instructions.
Caution
To get the best print
quality, do not store the
photoconductor unit in
an area subject to direct
sunlight, dust, salty air,
or corrosive gasses
(such as ammonia).
Avoid locations subject
to extremes or rapid
changes in heat or
humidity.
Keep the
photoconductor unit out
of the reach of children.