Filter
Top Products
2-3
Monitoring the Printer | 2-3
Saving Power in Standby Modes
The printer has two power-saving modes, Standby Level 1 and Standby
Level 2. In both modes, the printer saves power by lowering the fuser
temperature.
The printer enters Standby Level 1 when it is idle for 30 minutes. It takes
approximately one minute to warm up when you send a print job. The
printer enters Standby Level 2 when it is idle for 60 minutes. It takes
approximately five minutes to warm up when you send a print job.
You can disable the power-saving modes if necessary. See page 3-9 for
instructions.
Resetting the Printer
If you decide to cancel a print job after the printer has started processing it,
you can reset the printer. You may also need to reset after certain errors
occur (see the list on page 2-7). Resetting stops the printer and clears the
current print job.
•
To reset the printer, hold down the
Alt
and
Reset
buttons until
Reset
appears on the display.
•
To clear all jobs from the printer’s memory and cancel all printer
settings, hold down the
Alt
and
Reset
buttons until
Reset All
appears
on the display. This has the same effect as turning off the printer and
then turning it back on.
^
Paper Source
Menu
RITech
Page Size
Item
Copies
Manual Feed
Value
MP Tray Size
Orientation
Enter
Out Bin
AltReset
ContinueForm FeedOn Line
Reset
button
Alt
button