Filter
Top Products
9
Introduction | 9
•
Do not use a toner cartridge for at least one hour after moving it from a
cool to a warm environment.
•
Keep the fuser oil roll horizontal at all times. To avoid oil leakage and
reduced print quality, do not tilt the roll or let it touch anything.
•
When removing the photoconductor unit, avoid exposing it to room
light any longer than necessary. The unit contains a light-sensitive
drum, which is the green cylinder that can be seen through the openings
in the unit. Exposure to light can damage the drum, causing dark or
light areas to appear on the printed page and reducing the service life of
the drum. If you need to keep the unit out of the printer for long
periods, cover it with an opaque cloth.
•
Be sure not to scratch the surface of the drum. When you remove the
photoconductor unit from the printer, always set the unit on a clean,
smooth surface. Also, avoid touching the drum, since oils from your skin
can permanently damage its surface and may affect print quality.
•
To get the best print quality, do not store the photoconductor unit in an
area subject to direct sunlight, dust, salty air, or corrosive gasses (such as
ammonia). Avoid locations subject to extremes or rapid changes of heat
or humidity. Also, be sure to keep the consumable components out of
the reach of children.
•
Jammed paper can cause the printer to overheat. Do not leave jammed
paper in the printer.
photoconductor
unit