Filter
Top Products
3-13
Configuring the Printer | 3-13
Setting LJ4 Emulation Options
The LJ4 menu lets you make font and symbol settings when you use the
printer in LJ4 emulation mode. Normally you can make these settings
through your software. You only need to use these settings if you are using
software that can’t control fonts.
LJ4 menu settings
Setting Options Description
Font Source Resident, DIMM,
Download
Selects the source of fonts used for
printing; DIMM selects fonts in
memory.
Font Number From 0
upwards
(maximum value =
65535)
Selects the font for the print job. You
can print a font sample sheet (Test
Menu) to determine the font numbers.
Pitch 0.44 to 99.99 cpi in
steps of 0.01 cpi;
default is 10.00
Selects the pitch (the horizontal
spacing) of the font used in the print
job, if the font is scalable and is
fixed-pitch. The font pitch is expressed
in cpi (characters per inch).
Height 4.00 to 999.75 pt in
steps of 0.25 pt
Selects the height of the font used in
the print job, if the font is a proportional
scalable font. The height is expressed
in points.
SymSet 32 symbol sets plus
19 international
variations of the
Roman 8 set
Selects the symbol set of the font
used in the print job.
Form 5 to 128; default
is 60
Sets the number of lines for the
selected paper size and orientation.
This causes a line spacing (VMI)
change, which is stored in the printer.
Any later changes in the Page Size or
Orientation settings cause changes to
this Form value, based on the VMI
settings stored here.
Source
SymSet
0 to 3199 You can only make these settings if an
optional font ROM has been installed.
Dest SymSet 0 to 3199
Note
Font pitch and height
depend on the font
selected. Available
symbol sets also depend
on the fonts installed.