Epson TM-T88III Printer User Manual


 
CONFIDENTIAL
Paper roll Bit-image commands FS p
Ver. 10.01 p. 208
[Notes]
This command is not effective when the NV bit image specified by
n
has not been defined.
In standard mode, this command is effective only when there is no data in the print buffer and the printer
is at the beginning of the line.
In page mode, the NV bit image is only stored in the print buffer and is not printed.
If the NV bit image exceeds one line of print area, the printer does not print it.
The scales for width and height of NV bit images are specified by
m
. Therefore, in page mode with 90° or
270° clockwise-rotated NV bit image, the printer applies print area and dot density from [width: direction
of paper feed, height: perpendicular to direction of paper feed].
This command is not affected by print modes (such as emphasized, underline, character size, or 90° rotated
characters), except upside-down print mode.
This command executes paper feed for amount needed for printing the NV bit image regardless of paper
feed amount set by a paper feed setting command.
After printing the bit image, this command sets the print position to the beginning of the line.
When printing the NV bit image, selecting unidirectional print mode with ESC U enables printing
patterns in which the top and bottom parts are aligned vertically.
The NV bit image is defined by FS q.
NV bit image is printed in the default dot density (dot density of vertical and horizontal direction in
normal mode) defined by GS L <Function 49>.
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-T88III, TM-U220