Filter
Top Products
CONFIDENTIAL
Paper roll Miscellaneous commands GS P
Ver. 10.01 p. 470
GS P
SETTING COMMAND
[Name] Set horizontal and vertical motion units
[Format] ASCII GS P
x
y
Hex 1D 50
x
y
Decimal 29 80
x
y
[Range] 0 ≤
x
≤ 255
0 ≤
y
≤ 255
[Default] TM-J2000/J2100, TM-T88III, TM-L60II:
x
= 180,
y
= 360
TM-T90:
x
= 180,
y
= 360 [Other than Japanese model]
x
= 203,
y
= 406 [Japanese model]
TM-L90:
x
= 203,
y
= 406
[Printers not featuring this command] TM-P60, TM-U230, TM-U220, TM-U210, TM-U300A/B
[Description] Sets the horizontal and vertical motion units to approximately 25.4/
x
mm {1/
x
"} and approximately 25.4/
y
mm {1/
y
"}, respectively.
• When
x
= 0, the default value of the horizontal motion unit is used.
• When
y
= 0, the default value of the vertical motion unit is used.
[Notes]
■ The horizontal direction is perpendicular to the paper feed direction and the vertical direction is the paper
feed direction.
■ The horizontal and vertical motion units indicate the minimum pitch used for calculating the values of
related commands (shown on the next screen).
■ In standard mode, the following commands use
x
or
y
.
• Commands using
x
: ESC SP, ESC $, ESC \, GS L, and GS W
• Commands using
y
: ESC 3, ESC J, ESC K, GS A and GS V
■ In page mode, the following commands use
x
or
y
, when the starting position is set to the upper left or
lower right of the print area using ESC T.
• Commands using
x
: ESC SP, ESC $, ESC W, ESC \ and FS S.
• Commands using
y
: ESC 3, ESC J, ESC K, ESC W, GS $, GS A, GS V, and GS \
Miscellaneous commands