Filter
Top Products
CONFIDENTIAL
Paper roll Miscellaneous commands GS ( K
Ver. 10.01 p. 445
TM-P60
This printer does not support this function.
TM-T90
The following print densities are available.
A criterion density is the print density set by Function 5 (a = 5) of GS ( E.
The print density actually set is as follows.
For Example: If (m = 4) is specified when 90% in a standard density is set, the print density becomes 110%
[90%×120%].
The print density can be only within the range of 70% to 130%. When it is set to exceed 130%, the print
density becomes 70% or 130%.
For example: If (m = 6) is specified at 120% in a standard density, the print density becomes 130%
though the calculated value is 150% [120%×130%].
m
Print density
250 Criterion density × 70%
251 Criterion density × 75%
252 Criterion density × 80%
253 Criterion density × 85%
254 Criterion density × 90%
255 Criterion density × 95%
0 Criterion density
1 Criterion density × 105%
2 Criterion density × 110%
3 Criterion density × 115%
4 Criterion density × 120%
5 Criterion density × 125%
6 Criterion density × 130%