Filter
Top Products
CONFIDENTIAL
Paper roll Bit-image commands FS p
Ver. 10.01 p. 211
TM-T88III
This command can be used in standard mode. The dot density and the maximum print area are
described in the next tables (dpi: number of dots per 25.4 mm).
“Vertical” is in the direction of paper feeding and “horizontal” is perpendicular to the direction of
paper feeding.
The maximum print area in the vertical direction is information used when graphics are printed
with the page mode selected (for the starting position specified with ESC T is “Upper right” or
“Lower left”). In this case, bit images rotated by 90 degrees or 270 degrees are printed.
TM-U220
The modes selectable by
m
are as follows:
■ “Vertical” is in the direction of paper feeding and “horizontal” is perpendicular (at right
angles) to the direction of paper feeding.
■ The maximum number of dots for printing depends on the setting of DIP switch [SW2-1] and
paper width. See the description of GS ( E <Function 5> for details.
dpi: dots per 25.4 mm (dots per inch)
Scaling
Vertical Horizontal
Dot density Maximum print area (dot) Dot density
Maximum print area (dot)
Paper width 80 mm Paper width 58 mm
× 1 180 dpi 831 180 dpi 512 360
×
2 90dpi 415 90 dpi 256 180
Scaling Vertical Horizontal
Dot density Dot density Maximum number of dots
SW2-1: ON SW 2-1: OFF
Paper Width:
76/ 69.5/ 57.5 (mm)
Paper Width
76/ 69.5/ 57.5 (mm)
×
1 72 dpi 160 dpi 385/ 360 / 297 400/ 360/ 300
×
2 -- 80 dpi 192/ 180/ 148 200/ 180/ 150