Filter
Top Products
CONFIDENTIAL
Paper roll Bit-image commands GS ( L GS 8 L
Ver. 10.01 p. 270
❏ Specify left margin as 0, and the horizontal position to a position that is a multiple of 8, and
specify the horizontal size of the graphic to the dot which is the multiple of 8.
(Example: the left margin = 0, horizontal position = 8, 16, or 24, or 32 etc., (xL + xH × 256) = 64, or
128, or 256 etc.)
❏ Specify the scaling to the original size (bx = 1, by = 1).
❏ Specify the size of image data not to exceed the current print area.
❏ A graphic that exceeds the size limit of (yL + yH × 256) can be printed by the repeated use of the
combination of this function and <Function 50> of this command. In that case, the performance
may be best when the vertical size is specified as [59 ≤ (yL + yH × 256) ≤ 246 (reference value)] by
this function. However, the value is only a reference value. The most suitable vertical size
depends on the specifications of the PC, the interface used and other factors.
If using a serial interface or the time of processing this function cannot be shortened when
processing the above-mentioned item, the printing result may include horizontal stripes. In this
case, transmit the graphic data specified within the maximum range of (yL + yH × 256) one time to
prevent the horizontal stripe.
Specify the horizontal size of graphics as 64 dots and horizontal single × vertical single size
settings
[(yL + yH × 256) = 64, bx = 1, by = 1] when setting the dot density to [180 dpi × 180 dpi] with
Function 49.
The dot density and maximum print area are the same as Function 69. See the model information
of Function 69.
TM-P60
This function cannot be used when the printer enters the “beginning of the line” or “data in print
buffer” state during the standard mode.
Use the following settings for fastest processing time.
❏ Not RS-232 serial interface communication.
❏ Specify standard mode.