Epson TM-T88III Printer User Manual


 
CONFIDENTIAL
Paper roll Line spacing commands ESC 3
Ver. 10.01 p. 99
TM-T88III
The vertical or horizontal motion unit is specified by GS P.
In standard mode, if the character height is greater than the line spacing specified by this
command, the paper is fed the amount of the character height. For example, if a line spacing of
30 dots is specified with this command, but the characters used are double height Font A
(48 dots), the paper is fed 48 dots.
The amount of paper feed of the Japanese Kanji model can specify up to 900 mm {35.4 inches}.
When the amount of paper feed which exceeds the maximum value is specified, the paper feed of
the maximum amount is executed.
TM-L60II
The vertical or horizontal motion unit is specified by GS P.
TM-L90
The vertical or horizontal motion unit is specified by GS P.
In standard mode, if the character height is greater than the line spacing specified by this
command, the paper is fed the amount of the character height. For example, if a line spacing of
30 dots is specified with this command, but the characters used are double height Font A
(48 dots), the paper is fed 48 dots.
The amount of paper feed can specify up to 900 mm {35.4 inches}. When the amount of paper feed
which exceeds the maximum value is specified, the paper feed of the maximum amount is
executed.
TM-P60
The vertical or horizontal motion unit is approximately 0.125 mm {1/203 inches}. This value equals
one dot pitch.
In standard mode, if the character height is greater than the line spacing specified by this
command, the paper is fed the amount of the character height. For example, if a line spacing of
30 dots is specified with this command, but the characters used are double height Font A
(48 dots), the paper is fed 48 dots.