Filter
Top Products
CONFIDENTIAL
Paper roll Character commands ESC SP
Ver. 10.01 p. 103
ESC SP
SETTING COMMAND
[Name] Set right-side character spacing
[Format] ASCII ESC SP
n
Hex 1B 20
n
Decimal 27 32
n
[Range] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90,
TM-L60II, TM-P60, TM-U230, TM-U220, TM-U210: 0 ≤
n
≤ 255
TM-U300A/B: 0 ≤
n
≤ 32
[Default]
n
= 0
[Printers not featuring this command] None
[Description] Sets the right-side character spacing to
n
× (horizontal or vertical motion unit).
[Notes]
■ The character spacing set by this command is effective for alphanumeric, Kana, Thai, and user-defined
characters.
■ When characters are enlarged, the character spacing is
n
times normal value. The character spacing for
double-width mode is twice the normal value.
■ When standard mode is selected, the horizontal motion unit is used.
■ When page mode is selected, the vertical or horizontal motion unit is used for the print direction set by
ESC T.
• When the starting position is set to the upper left or lower right of the print area using ESC T, the
horizontal motion unit is used.
• When the starting position is set to the upper right or lower left of the print area using ESC T, the
vertical motion unit is used.
■ The character spacing can be set independently in standard mode and in page mode.
• In standard mode this command sets the character spacing of standard mode.
• In page mode this command sets the character spacing of page mode.
■ If the horizontal or vertical motion unit is changed after this command is executed, the character spacing is
not changed.
Character commands