Filter
Top Products
CONFIDENTIAL
Paper roll Customize commands GS ( M
Ver. 10.01 p. 633
GS ( M pL pH fn m <Function 3>
[Name] Select the setting values loaded to the work area after the initialization process
[Format] ASCII GS ( M
pL pH fn m
Hex 1D 28 4D
02 00 fn m
Decimal 294077
2 0fnm
[Range] (
pL
+
pH
× 256) = 2, (
pL
= 2,
pH
= 0),
fn
= 3, 51
TM-J2000/J2100, TM-T90, TM-L90, TM-P60:
m
= 0,1, 48, 49
[Default]
m
= 0
[Description] Selects the command setting values loaded to the work area after the printer performs the initialization
process.
• When
m
= 0, 48, the default values described in this guide are applied.
• When
m
≠ 0, 48, the setting values are stored in the storage area specified by
m
.
[Notes]
■ This function does not change the values in the work area and storage area.
■ The setting of this function affects the following initializations.
• Turning on the power.
• Resetting the hardware by using a reset terminal.
• Executing ESC @.
• Executing a software reset.
■ The specification of this function is maintained after turning off the power.
■ In autoload processing, the values of the commands that are in the work area and are not affected by this
function and the values in the storage area are not changed.
■ The values affected by autoload processing of this function are different, depending on the printer
models. See model-dependent variations for details.