Filter
Top Products
CONFIDENTIAL
Paper roll Customize commands GS ( M
Ver. 10.01 p. 632
GS ( M
p
L
p
H
fn m
<Function 2>
[Name] Load the setting values stored in the storage area to the work area
[Format] ASCII GS ( M
pL pH fn m
Hex 1D 28 4D
02 00 fn m
Decimal 294077
2 0fnm
[Range] (
pL
+
pH
× 256) = 2, (
pL
= 2,
pH
= 0),
fn
= 2, 50
TM-J2000/J2100, TM-T90, TM-L90, TM-P60:
m
= 0,1, 48, 49
[Description] Loads the command setting values stored in the storage area specified by
m
to the work area.
• When
m
= 0, 48, the default values described in this guide are applied.
• When
m
≠ 0, 48, the setting values are stored in the storage area specified by
m
.
[Notes]
■ This function is effective at the beginning of a line in standard mode.
■ This function cannot be included in a macro. Do not use this function when executing a macro.
■ The value in the work area is set to the default value by the following:
• Executing this function by specifying
m
= 0, 48.
• Executing Function 2 with the condition that the storage area that has not executed Function 1 is
specified.
• Initializing when an autoload process has been canceled by Function 3.
■ The values in the work area that are not affected by this command are not changed.
■ The values in the storage area are not changed.
■ The values affected by this command are different, depending on the printer models. See model-
dependent variations for details.