Filter
Top Products
Specifications
A-9
4. Press the E load/eject button to print the default font and
character table and the next page of instructions.
The instruction sheet lists all of the fonts and character tables you
can select.
5. Select the font and character table you want to use.
6. Exit the default setting mode by turning off the printer.
If you want to check the current default font and character table, enter
the default setting mode again and print the current settings, which
are indicated by arrows.
Note:
You may exit default setting mode any time by turning off the printer. Any changes you made
remain in effect until you change them again.
Command List
This section lists the available printer commands by topic. Your
printer works with the following commands.
ESC/P 2 control codes Selecting EPSON ESC/P 2 printer in your software allows you to use
the most advanced font and graphics handling available. See the
ESC/P
Reference Manual for details.
General operation ESC @, ESC U, ESC EM
Paper feeding CR, FF, LF, ESC 0, ESC 2, ESC 3, ESC +
Page format ESC ( C, ESC C, ESC C0, ESC Q, ESC l, ESC ( c, ESC N, ESC O
Print position
motion
ESC $, ESC \, ESC ( V, ESC ( v, ESC D, HT, ESC B, VT, ESC J
Font selection ESC k, ESC x, ESC X, ESC P, ESC M, ESC g, ESC p, ESC 4, ESC 5,
ESC E, ESC F, ESC !
Font enhancement ESC W, DC4, SO, DC2, SI, ESC w, ESC G, ESC H, ESC T, ESC S,
ESC -, ESC ( -, ESC q
Spacing ESC Space, ESC c, ESC ( U
Character handling ESC t, ESC ( t, ESC R, ESC %, ESC &, ESC :, ESC 6, ESC 7,
ESC ( ^
Bit image ESC *
Graphics ESC ( G, ESC ., ESC ( i, ESC ( e, ESC ( \, ESC ( s
Color ESC r, ESC ( r
Printing mode ESC ( K
specs.fm5 Page 9 Thursday, July 24, 1997 3:12 PM