Filter
Top Products
3.
Press
the FORM FEED
(A)
button to feed
the
paper forward or the
LINE FEED
(V
) button to feed the paper backward.
Note: The printer beeps when the paper reaches a position that is
approximately l/3 of an inch from the top edge of the paper. You
can use this position as a reference point when you adjust the
printer’s loading position.
4.
Once you have adjusted your paper, press the
MICRO FEED
button
again to turn off this feature.
Short Tear-Off
There are two ways of operating the short tear-off feature. The easier
way is to set the
AUTO TEAR OFF
option with SelecType. When you
have
finished printing and if the perforation is at the top of form position, the
printer automatically feeds
the
perforation of the continuous paper to
the
tear-off edge of the paper guide cover so you can tear off
the
last printed
sheet. When you resume printing,
the
paper automatically feeds back to
the loading position. See the CHANGE MACRO section in this chapter
for instructions on setting the
fYJT0
TEAR
DFF
option.
The other way to operate the short tear-off feature is by using the
TEAR
OFF
button on the control panel to feed the perforation of your
Using the Printer
3-31