Filter
Top Products
DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation 15
Secondary functions (
•
):
• Select a global preset (see “Saving and Recalling Presets” on page 29).
• Output 1 only: With the Input 1 button, places the switcher in I/O grouping
mode (see “I/O Grouping” on page 32).
• Mute and unmute an output (see “Muting and Unmuting Video and Audio
Outputs” on page 36).
Configuration Port
c Config port — This RS-232 port is an alternative to the Remote RS232/RS422
connector on the DXP rear panel (see “g Remote RS232/RS422 connector” on
page 9 for a description). The port (RS-232 only) can be used for system configuration
and control via SIS commands or the control software. To connect to the Config port,
see “RS-232 Config port (front panel)” on page 11.
Control Buttons
The following table summarizes the primary and secondary functions of the four
control buttons.
Primary Functions
ENTER PRESET
VIEW
ESC
Action: Save changes.
Select preset
mode.
Select view
mode.
Cancel or
escape.
Indication:
Blink: Save
needed
Blink: Save preset.
Lit: Recall preset.
View the selected
mode.
Blinks once.
Secondary Functions
I/O Grouping
Action/
indication:
Select group 1. Select group 2. Select group 3. Select group 4.
Port
configuration
Action 1: Select Configuration Mode
Action 2/
indication:
Select 9600 baud.
Blink: Selected
Select 19200 baud.
Blink: Selected
Select 38400
baud.
Blink: Selected
Select 115200
baud.
Blink: Selected
Front panel
locks
Action:
With Video and
Audio, select lock
mode 2 or toggle
between modes 0
and 2.
d Enter button — The Enter button does the following:
Primary functions (❏):
❏ Saves changes that you make on the front panel.
❏ Indicates that a potential tie has been created but not saved.
❏ Indicates that a global preset has been selected to be saved or recalled but that
the preset action has not been accomplished.