Filter
Top Products
HTML Control and IPL File Manager, cont’d
GSS 100 Graphic Still Store • HTML Control and IPL File Manager
GSS 100 Graphic Still Store • HTML Control and IPL File Manager
5-105-10
5-115-11
Gateway IP Address field
N
This field is grayed out and uneditable if DHCP is on.
The Gateway IP Address field identifies the address of the
gateway to the server that is to be used if the GSS and the server
are not on the same subnet.
The gateway IP address has the same validity rules as the GSS’s
IP address. The default is 000.000.000.000.
Click the Submit button to take changes. Click the Cancel
button to abandon them.
Subnet Mask field
N
This field is grayed out and uneditable if DHCP is on.
The Subnet Mask field is used to determine whether the GSS is
on the same subnet as the GSS’s server when you are subnetting.
The default is 255.255.000.000.
Click the Submit button to take changes. Click the Cancel
button to abandon them.
MAC Address field
The Media Access Control (MAC) Address is hardcoded in the
GSS and cannot be changed.
Date/Time Settings fields
The Date/Time Settings fields provide a location for viewing
and setting the time functions.
N
If setting the time, set the local time. The Zone variable
allows you to then enter the offset from Greenwich Mean
Time (GMT).
N
The Zone field identifies the standard time zone that
was selected; and displays the amount of time, in hours
and minutes, that the local time varies from the GMT
international time reference.
N
When the daylight savings time feature is turned on, the
GSS automatically updates its internal clock between
Standard Time and Daylight Savings Time in the spring
and fall on the date that the time change occurs in the
United States of America, Brazil, or Europe (depending
on the radio button selected). When the daylight savings
time feature is turned off, the GSS does not adjust its
time reference.
Click the Submit button to take changes. Click the Cancel
button to abandon them.
Video Settings Page
Access the Video Settings page (figure 5-5) by clicking the
Configuration tab and then the Video Settings link on the left
side of the System Settings page.
System
Settings
Email Alerts
Firmware
Upgrade
Passwords
Figure 5-5 — Video Settings page
Set the video settings (resolution, refresh rate, sync format, and
sync polarity) and RGB delay as follows:
1. Click the desired field. A drop down scroll box appears
(figure 5-6).
Figure 5-6 — Output Configuration drop boxes
N
The RGB Delay drop box is shown at the right of the
page rather than under the Resolution box for clarity
only.
2. If necessary, click and drag on the slider or click the scroll
up ( ) or down ( ) button until the desired setting is
visible.
3. Click the desired setting.