Filter
Top Products
Operation and Configuration, cont’d
System 7SC • Operation and Configuration3-20
System Remote
Control Functions Audio
Input Selection
COLOR
TINT
CONT
BRIGHT
DETAIL
Display
Power
Display
Mute
Mode
Mute
Volume
ENTER
SHIFT
Room 1
Room 2
Image Adjustments
4321
8765
09
IR 701
IR 701 infrared remote control
The IR 701, shown at right, replicates all of the front panel
controls except the Menu and Next buttons. Unless executive
mode is enabled, adjustments can be made from the IR 701, but
you must use the System 7’s front panel or the Windows-based
control program (via an RS-232 device) to configure and program
the switcher. See chapter four, “Serial Communication”, for
details.
The topmost part of the IR 701 includes the control functions
(Display Power, Mute, Mode) and the master volume control (as
^
and buttons). The middle portion of the IR 701 features the
input selection buttons, Room 1, Room 2, and centering/shift
buttons. The bottom part contains the adjustment controls for
color, tint, brightness, contrast, and detail adjustments. The
adjustment functions will be disabled if executive mode is on.
Selecting an input
To use the IR 701 to select an input, press the input number, then press the Enter
key. For example, if a switcher is slaved to the System 7 and you want to select
input 15, press 1, press 5, then press Enter. The System 7 will switch to input 15.
If you select an input that doesn’t exist, such as input 8 when a slave switcher is not
connected, the switcher will ignore the command.
^