Extron electronic System 7SC Switch User Manual


 
4-7System 7SC • Serial Communication
Command/response table for SIS commands (continued)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Executive mode (front panel lockout)
Disable 0X Exe0 Adjustments & selections can
be made from the front panel.
Enable (lock image adjustments) 1X Exe1 Lock front panel adjustments;
adjust image via RS-232 only.
Enable (lock selection & adjustments) 2X Exe2 Lock all front panel controls
(adjustments & input selection);
adjust via RS-232 only, select via
RS-232 or IR 701.
View the executive mode status X Exe
X16
Show executive mode status.
Example: X Exe0
Firmware version, part number & information requests
Query firmware version number Q Ver
X8
Show the controller firmware
version.
Request part number N N60-340-01 Show the switcher’s part #.
Request general info. I (See below.) Show the switcher’s status.
Vid
X1
•Aud
X1
•Std
X12
•Max
X5
Request projector configuration K (16 char + spc + 16 char) Show which projector driver is
being used. The response is a
string of 16 characters + space +
16 characters (total = 33
characters).
Example: K Proxima_XXXXXXXX•YYYYYYYYYYYYYYYY
Zap (reset to default settings)
Zap audio levels to 0 dB
Esc
zA ZapA Reset all audio levels to 0dB.
Zap image adjustments/controls
Esc
zI ZapI Reset the image adjustments to
factory settings.
Zap user learned IR drivers
Esc
zU ZapU Clear memory page 1 (remove
learned IR drivers).
Zap Extron downloaded drivers
Esc
zE ZapE Clear memory page 0 (remove
RS-232/IR projector drivers that
were created by Extron and
downloaded to the System 7
and remove user-entered RS-232
commands).
Zap all System 7 settings/memories
Esc
zXXX ZapXXX Reset everything: all settings,
adjustments, and drivers to the
factory default.