Filter
Top Products
Operating manual
CNC 8070
4.
MANUAL (JOG) MODE
Operations with the axes
(SOFT V03.0X)
72
4.2.4 Moving an axis to a particular position (coordinate)
When moving the axes to a specific position, they must do so one by one following
these steps:
2. Enter the coordinate of the target point.
3. Press [START] to execute the movement or [ESC] to cancel the operation.
Feedrate behavior
The moving feedrate depends on whether G00 or G01 is active.
• If G00 is active, the movement is carried out at the rapid rate defined by the
machine manufacturer.
• If G01 is active, the movement is carried out at the active feedrate. If no feedrate
is active, the movement is executed at the feedrate defined by the machine
manufacturer.
1. Select the axis to be homed using the alphanumeric keyboard. The CNC will
highlight that axis to indicate that it is selected.
To select the numbered axes (e.g. "X1"), select any axis and then move the
selection until positioning on the desired one. The focus moves with the [©][ª]
keys.
This feedrate may be varied between 0% and 200% using the feedrate override
switch
(a)
on the operator panel. The percentage will be applied on to all the
movements carried out in G00 and in G01.
(a)