Filter
Top Products
Operating manual
CNC 8070
14.
DDSSETUP
Changing the drives accessing level
(SOFT V03.0X)
304
14.4 Changing the drives accessing level
The parameters, variables and commands of the drive are organized by access
levels. To access each parameter, the drive must be configured at the access level
required by that parameter. A password is needed to access each level.
The available access levels are the following:
• Basic level (USER)
It is the default level, it is accessed when entering the DDSSetup mode. It requires
no password.
The user level gives access to a group of parameters that slightly changes the
operation of the drive.
• Intermediate level (OEM)
This level gives access to a large group of parameters that depend on the motor
connected, they set how the electronics of the drive is adapted to that motor.
• Maximum level (FAGOR)
This level gives full access to all the variables, parameters and commands of the
system.
This softkey is used to change the access level for drive parameters. Pressing this
softkey shows a window that requests the password to quit the basic level and access
a new level.
The Fagor level gives access to a group of parameters depending on the
drive's electronics and they factory set.
Only technicians from Fagor Automation are granted a FAGOR access level.