Filter
Top Products
Operating manual
CNC 8070
1.
GENERAL CONCEPTS
Description of the keys
(SOFT V03.0X)
8
1.3.3 Description of the operator panel
Depending on the utility of the different elements, the operator panel may be
considered to be laid out as follows:
JOG keys
They are used to jog the axes. There are two types of JOG panels:
There are two keys for each axis. One to jog the axis in the positive direction and
another one to move it in the negative direction.
There is a key for each axis and two keys for moving direction, common to all the axes.
Both keys (axis and direction) must be pressed to jog the axis.
Feed selectors
The operator panel has two selectors:
Jogging the axis in the positive direction.
The movement is carried out at the jog feedrate.
Jogging the axis in the negative direction.
The movement is carried out at the jog feedrate.
Rapid jogging of the axis.
When combined with another JOG key, it moves the axis at rapid jog feedrate.
Axis selection.
Selection of the moving direction.
Rapid jogging of the axis.
When combined with another JOG key, it moves the axis at rapid jog feedrate.
Movement type selector.
Select the type of jog movement, which may be either by handwheels, incremental
jog or continuous jog.
In handwheel mode, it selects the multiplying factor for the handwheel pulses (x1,
x10 o x100).
In incremental mode, it selects the incremental value of the axis movements.
Feedrate override % selector.
To select the override percentage to be applied to the programmed and jog
feedrates, between 0% and 200%.