Filter
Top Products
Operating manual
CNC 8070
7.
MDI MODE
Full MDI screen
(SOFT V03.0X)
158
7.3.1 Block execution
In this window, it is possible to edit and execute new blocks or the ones saved in the
block history.
Block editing
The blocks may be edited directly on the edit line or may be recalled from the block
history.
The recalled blocks may be modified before executing them as if they were new ones.
The blocks edited or modified appearing on the edit line may be executed or saved
in the block history.
Saving a block
Press [ENTER] to save a block in the history without executing it.
If it is a new block, it will be added to the history whereas if it is modified block, it will
replace the previous one in the history.
Block execution
The block on the edit line is executed by pressing [START] at the operator panel. Once
the block has been executed is saved in the block history.
The [STOP] key interrupts the execution of the block. Press [START] again to resume
execution from where it was interrupted.
The [RESET] key cancels the execution of the block and resets the CNC to its initial
conditions.
Keys for selecting a block from history
To access the history and select a block.
To accept the selection and show the block on the edit line.
To cancel the selection and quit the MDI mode.