Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
59
Reviewing the Module’s Programmed Default Temperature
Term Description Reference
Programmed
Default
Temperature
Upon initial power up, the Lamination
Module is programmed to heat the
Lamination Roller up to its default
temperature.
Target Temperature: If a print job is
sent while the lamination module is
heating up, the Printer's LCD display
will read Laminator Warming. This will
alternate with LAM Temp: [current]
[target] which shows the current
temperature of the Lamination Roller
and the target temperature it is trying
to reach. (Note: This indicates that
the lamination Roller is heating to its
preset temperature.)
Initial Heating Process: The initial
heating process will generally take
about 3 to 4 minutes. (Note: The
LCD display will read Laminator
Warming or Laminator Cooling
whenever the Lamination Roller is
heating up or cooling down to the
prescribed temperature. When the
Lamination Module has reached its
target temperature, lamination will
begin.)
See the Using the Lamination
tab (only with the Card
Lamination Module) in Section
5, page 228.