Filter
Top Products
FARGO Electronics Inc.
4-42 HDP700 Series Card Printer
4.8.7 Cleaning Roller Assembly
(840102)
Refer To Drawing 840156
Tools Needed
None
1. Open the Front Access Door.
2. Press the tab on the Cleaning Roller Assembly
3. Pull the Cleaning Roller Assembly from the printer.
4.8.8 Flipper Table Position Stepper Motor
(840124)
Refer To Drawing 840156
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Remove the screws from the Back Cover of the printer.
7. Tilt the Back Cover outwards from the printer.
8. Remove the screws from the back plate and move it far enough to allow access to the back of
the hopper assembly.
9. Disconnect the Stepper Motor Cable connection.
10. Remove the two screws (130314) that secure the Stepper Motor.
11. Lift the Stepper Motor carefully from the printer.
4.8.9 Card Feed Motor Assembly
(840198)
Refer To Drawing 840156
Tools Needed
Small Standard Screwdriver, Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).