Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer 3-9
Figure 3-6
The Vertical adjustment moves the image toward the rear of the printer if a positive number is
entered and toward the front of the printer if a negative number is entered. The Horizontal
adjustment moves the image toward the card output side of the printer if a positive number is entered
and toward the card input side of the printer if a negative number is entered. The maximum value for
the Vertical and Horizontal adjustments is ±100 pixels (10 pixels = 0.03" (.8mm)).
3.5.2 Transfer Dwell Time and Temperature
The Image Transfer option also allows control of the Transfer Dwell Time and Transfer
Temperature. See Figure 3-4. These settings control the speed and temperature at which printed
images are transferred from the HDP Film to the card. Depending on the card type, these settings may
vary. The printer driver automatically optimizes these settings according to the selection made in the
Card Type option. Any changes made to the dwell time and temperature settings will be saved for the
selected Card Type option upon exiting the printer driver setup in the printers control panel. To
return to the factory default settings for the selected Card Type, click on the Default button. See
Figure 3-4.
If using cards that differ from the Card Type Glossy-PVC or Matte-PVC options, select one of the
Card Type Custom options, then adjust the dwell time and temperature settings manually to ensure
proper image transfer.
To determine the appropriate settings for the card stock, set the Transfer Dwell Time and Transfer
Temperature to the default settings. Then, print a card. If the HDP Film is not transferring properly,
adjust these settings accordingly. Once the Film is transferring properly, perform a final durability
test called the "Tape Test." For instructions on how to do a tape test, see Section 3.2.3.
3.5.3 Flattener Temperature
The Flattener Temperature control sets the temperature of the printer's built-in Card Flattener.
Depending on the card type, this setting may vary. If using the standard UltraCard-Glossy or HDP
Card-Matte PVC Card Type option, the printer driver automatically optimizes this setting according to
whether printing single or dual-sided cards. In general, single-sided prints require a hotter Flattener
temperature. If using another type of card stock, it may be necessary to adjust this setting to optimize
the flatness of the cards. Any changes made to the Flattener temperature will be saved upon exiting
the printer driver setup. To return to the factory default setting, simply click on the Default button.
See Figure 3-4.