Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer A-11
Figure 7-11
7.3.15 Adjusting the Flipper Offset
1. Select MENU, Setup Printer, and Flipper Offset.
2. Change the setting in small increments if the card is not feeding correctly.
A negative adjustment will lower the side of the Flipper Table closest to the Exit Hopper.
3. Press SELECT to save the value.
7.3 Show Error Count
SHOW ERROR COUNT is a useful tool for troubleshooting the printer. It keeps a log of up to 255
errors and tracks how many times specific errors occur. This helps determine if certain errors are
occurring more than others and may pinpoint an area in the printer requiring attention.
Use the scroll buttons to move through the Exception Log. Press the RESET button to clear the
existing error log and start a new log. Note that the error log will stop logging errors once it has
reached its error occurrence limit of 255. See Interpreting LCD Display Messages in Section 4 for
information about these messages.
ERROR LOG START
Type of Error
Occurrences: X (Number of times).
ERROR LOG END
7.4 Show Card Count
Choose SHOW CARD COUNT to view counts for Card Count (CC), Pass Count (PC), and
Transfer Count (TC).
Card Count is the total number of cards the printer has produced.
Pass Count is the total number of print passes made by the Printhead; a pass is measured each
time a single ribbon panel is printed or passes beneath the Printhead.